Using A WLAN Network DiagramThe WLAN Network Diagram using WLAN Access Point 2330 is easy to install and efficient to use. Access point locations are mapped on a floor plan and locate the WLAN security switch when installed. It uses Ethernet ports for network backup in case the primary port fails. Buffering capacity is increased by up-to-date memory. It efficiently performs scheduled and/or automated RF scans, periodically sweeps all channels with no interruption to connectivity, looks for unauthorized activity, has dual internal radios and antennas, and provides accurate tuning via micro-adjustable power levels. There are a few things you need to think about when configuring your WLAN Network Diagram. Decide if you want to extend your network or you want to build a new network. Determine the number of wireless computers that will be in the network and where you plan to locate them. Choose which operating systems you’ll be using on all computers that are networked. Decide how this WLAN is going to be used. There are other things you will need to consider about your WLAN Network Diagram. You will need one wireless router for one WLAN and should only use a router for the following conditions: This is your first home network, you are re-building your home network so that it is wireless, or your goal is simplicity with WLAN installation. It is important to install your wireless router in a centralized location. Computers that are situated closer to the router seem to realize better network speed than those located further away. You will also need to select a network name and must be shared by the router and all computers on the WLAN. You will need one wireless access point for one WLAN. You should use a wireless access point if you decide that the extra features of a wireless router are not needed and you are extending an existing Ethernet home network that is wired or there are four or more wireless computers located in your home. As with a wireless router, your access point should be installed in a centralized location. Finally, you’ll need to configure your adapters and set them for infrastructure mode. They will automatically detect and set their WLAN channel number so that it perfectly corresponds to the access point or router.
|